[email protected]

(PDF) Comparison of microparticles and nanoparticles

Comparison of microparticles and nanoparticles effects on the microstructure and mechanical properties of steel-based composite and nanocomposite fabricated via accumulative roll bonding process. Materials Science & Engineering A 607 (2014) 173187 Contents lists available at ScienceDirect Materials Science & Engineering A journal homepage:elsevier/locate/msea Comparison of microparticles and nanoparticles effects on deformation COMPARISON OF TRIP STEEL MICROSTRUCTURES AFTER COMPARISON OF TRIP STEEL MICROSTRUCTURES AFTER THERMO-MECHANICAL TREATMENT WITH ISOTHERMAL AND ANISOTHERMAL DEFORMATION STEPS Skálová L.1,2, Staková H.1,3, Jandová D.2,4, Maek B.1,3 1University of West Bohemia in Pilsen, Research Center FORTECH, Univerzitni 8, 306 14, Pilsen, Czech Republic

Effect of Isothermal Treatment on Microstructure and

  • AbstractIntroductionMaterials and MethodsResults and DiscussionConclusionsData AvailabilityConflicts of InterestAcknowledgmentsIn this study, we investigated the recrystallisation kinetics of Ti-stabilised interstitial-free (IF) steel manufactured by the Mexican steel industry through the route of electric arc furnace with vacuum degassing, secondary refining, and subsequent continuous casting. The IF steel was hot-rolled at 950°C and then cold-rolled until deformation of 94% was attained, followed by recrystallisation at different times at a constant temperature of 780°C. In addition, the mechanical properties of the IF steel were assess(PDF) The Microstructure and Mechanical Properties of As The Microstructure and Mechanical Properties of As-rolled Dual Phase Steel:Part I-Manganese Partitioning and Microstructure. By Shoujin Sun. Microstructural Evolution of Cr-Rich ODS Steels as a Function of Heat Treatment at 475 °C. Microstructure, Mechanical Properties, and Corrosion The paper presents results of the investigations on the effect of low-temperature thermomechanical treatment (LTTT) on the microstructure of AlZn6Mg0.8Zr alloy (7000 series) and its mechanical properties as well as electrochemical and stress corrosion resistance. For comparison RETRACTED-Effect of electropulsing treatment on the Jul 24, 2014 · C. Microstructure and mechanical property of the samples after high-frequency EPT. Obvious phase change occurred at high-frequency EPT (360493 Hz) and was observed by the help of the XRD and microstructure. At this period, there is an occurrence of duplex microstructure with the equiaxed grains and lamellar grains.

    Right ventricular myocardial mechanics:Multi-modal

    Presently, little is known about its mechanics, its microstructure, and its constitutive behavior. In this work, we set out to provide the first data on the mechanics of the matur Right ventricular myocardial mechanics:Multi-modal deformation, microstructure, modeling, and comparison to the left ventricleEffect of pre-deformation on microstructure and deformation is about 6.5%, as shown in Fig. 5(a) and Fig. 5(b). In comparison, the size of dimple shown in Fig. 4 Effect of pre-deformation on mechanical properties:(a) Strength; (b) Elongation Fig. 5(b) is smaller than that in Fig. 5(a), the depth of dimple is much shallower and its distribution is more uniform.